C4AH1KF1 - 307

REPLACEMENT A POST STIFFENER

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - SPECIAL FEATURE

On refitting the a post stiffener, refit it using the jig tool .

2 - COMPLEMENTARY OPERATION(S)

REPLACEMENT OF THE A POST .

3 - IDENTIFICATION OF REPLACEMENT PARTS

Assembled front pillar stiffener .

4 - REPLACEMENT PART COMPOSITION

(1) Door stop yoke stiffener .

(2) Assembled front pillar stiffener .

(3) A post lower gusset .

(4) A post inflating insert bracket .

5 - PREPARATION OF THE NEW PART

A post inner panel assembly .

6 - PREPARATION OF THE NEW PART

7 - CUTTING OUT

8 - RELEASING

9 - ADJUSTMENT

10 - WELDING

11 - PROTECTION