C4AH1NF1 - 307

REPLACEMENT FRONT PART CHASSIS LEG

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• engine compartment upper front half panel
• front wheel arch - front part

2 - IDENTIFICATION OF REPLACEMENT PARTS

(1) Front part chassis leg (Specific to repair) .

(2) Chassis leg closing .

3 - REPLACEMENT PART COMPOSITION

(3) Front part chassis leg .

(4) Engine compartment panel support .

(5) Chassis leg end piece .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

(1) Front part chassis leg (Specific to repair) .

(2) Chassis leg closing .

5 - PREPARATION OF THE NEW PART

6 - TOOLING

Templates for marking the front chassis legs cut-out (Right-hand side [1] - On the left-hand side [2]) .

[1] Tool for marking out the front section of the right chassis leg .

[2] Tool for marking out the left front chassis leg section .

7 - CUTTING OUT

8 - SEPARATING

9 - ADJUSTMENT

10 - WELDING

11 - PROTECTION