C4BH36F1 - 307 5 DOOR SALOON

REPLACEMENT REAR WING ASSEMBLY

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• roof
• TAIL PANEL ASSEMBLY

Removal - refitting :

• REAR BUMPER
• REAR WING LIGHT
• TAILGATE
• rear wheel
• rear mud guard
• door striker
• DOOR SEAL ON BODY
• rear seat
• fuel filler flap actuator (right side)
• fuel filler cap (right side)
• FUEL TANK (right side)

Remove-refit trim :

• rear floor
• wing inner panel trim
• rear quarter
• tailgate seal

Detach the electrical harnesses .

2 - IDENTIFICATION OF REPLACEMENT PARTS

Rear wing assembly .

3 - REPLACEMENT PART COMPOSITION

(1) Rear wing .

(2) Rear door striker stiffener .

(3) Rear bumper bracket .

(4) Rear light housing closing .

(5) Rear light outer housing .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

5 - PREPARATION OF THE NEW PART

6 - CUTTING OUT

7 - RELEASING

8 - ADJUSTMENT

9 - WELDING

10 - CRIMPING

11 - FINISHING

12 - SEALING

13 - PROTECTION