C4BH37F1 - 307 3 DOOR SALOON

REPLACEMENT REAR WING ASSEMBLY

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - REAR WING ASSEMBLY

Replacement :

• ROOF
• tail panel assembly

Removal - refitting :

• REAR BUMPER
• REAR WING LIGHT
• TAILGATE
• quarter light
• mud guard
• BODY WAIST LEVEL PROTECTORS
• tailgate aperture seal
• door aperture seal
• quarter light seal
• fuel filler flap actuator (right side)
• fuel filler cap (right side)
• FUEL TANK (right side)
• front seat
• rear seat (rear seat cushion - backrest)

Remove-refit trim :

• rear wing inner panels
• rear pillar

Detach the electrical harnesses .

Protect :

• the front carpet and boot carpet

2 - SPECIAL FEATURES

On adjustment of the rear wing assembly, use either the jig tools or mechanical or electronic measuring equipment .

3 - IDENTIFICATION OF REPLACEMENT PARTS

Rear wing assembly .

4 - REPLACEMENT PART COMPOSITION

(1) Rear wing .

(2) Rear bumper bracket .

(3) Rear light housing closing .

(4) Rear light outer housing .

(5) Rear wing upper gutter .

(6) Tailgate strut fixing stiffener .

5 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

6 - PREPARATION OF THE NEW PART

7 - CUTTING OUT

8 - RELEASING

9 - ADJUSTMENT

10 - WELDING

11 - CRIMPING

12 - FINISHING

13 - SEALING

14 - PROTECTION