C4BH38F1 - 307

REPLACEMENT PART REAR FLOOR

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• REAR BUMPER
• TAIL PANEL ASSEMBLY
• TAILGATE
• SOUND DEADENING PADS

Tilt and protect the seat cushions .

Removal - refitting :

• spare wheel
• seat backrest
• central seat belt
• seat belt buckle straps
• FUEL TANK

Remove-refit trim :

• side panel
• rear floor

Detach the electrical harnesses .

2 - IDENTIFICATION OF REPLACEMENT PARTS

3 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

4 - PREPARATION OF THE NEW PART

5 - CUTTING OUT

6 - RELEASING

7 - ADJUSTMENT

8 - WELDING

9 - SEALING

10 - PROTECTION