C4BH3CF1 - 307

REPLACEMENT PART SIDE MEMBER

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : place the air bag in contact with the generator for safety reasons .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• rear floor
• WING INNER PANEL ASSEMBLY

2 - IDENTIFICATION OF REPLACEMENT PARTS

(1) Rear load floor extension .

(2) Specific repair side member .

(3) Side member rear stiffener(Right-hand side only) .

3 - REPLACEMENT PART COMPOSITION

(1) Load floor extension .

(3) Side member rear stiffener(Right-hand side only) .

(4) Rear side member cut .

(5) Rear side member closing panel .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

(1) Rear load floor extension .

(2) Specific repair side member .

(3) Side member rear stiffener(Right-hand side only) .

5 - CUTTING OUT

WARNING : right-hand side only .

6 - SEPARATING

WARNING : right-hand side only .

7 - ADJUSTMENT

WARNING : right-hand side only .

8 - WELDING

WARNING : right-hand side only .