C4CH24F1 - 307 3 DOOR SALOON

REPLACEMENT PART C POST - "C" POST INNER PANEL

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• FRONT DOOR
• PART REAR WING
• OUTER SILL

2 - SPECIAL FEATURES

On adjustment of the rear wing assembly, use either the jig tools or mechanical or electronic measuring equipment .

3 - IDENTIFICATION OF REPLACEMENT PARTS

(1) Rear pillar assembly .

(2) "C" post inner panel .

4 - REPLACEMENT PART COMPOSITION

(3) Rear pillar .

(4) C post stiffener .

(5) Front door tapping plate - tapping plate cage assembly .

(6) Anchoring ramp support .

(7) Rear post partition .

5 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

(8) Cut c post assembly .

(2) "C" post inner panel .

6 - PREPARATION OF THE NEW PART

7 - CUTTING OUT

8 - RELEASING

9 - ADJUSTMENT

10 - WELDING

11 - PROTECTION