C5FG2GF1 - 307

REMOVAL - REFITTING BUILT-IN SYSTEMS INTERFACE

1 - REMOVAL

Disconnect the battery .

Remove the cover (1) unclipping it downwards .

On each side of the bsi :

• release the fixings (2) by a quarter turn
• move aside the lower tabs (3) and tilt the bsi

Disconnect all the bsi connectors .

Lift the rear of the bsi slightly and pull it towards you to detach it from its bracket .

Remove the bsi .

2 - REFITTING

Position the bsi in its bracket, engaging the pins (4) in the notches (5) on each side .

Connect all the bsi connectors .

Continue the fitting operations in the reverse order to removal .

If the built-in systems interface is replaced, configure it using the DIAG 2000 .

Check operation .