C4BH2KF1 - 607

REPLACEMENT OF THE LOWER WING DRIP MOULDING AND THE REAR LIGHT UNIT

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Removal - refitting :

• TAIL PANEL ASSEMBLY
• TAIL LAMPS

2 - IDENTIFICATION OF REPLACEMENT PARTS

(1) Rear wing lower drip moulding assembly .

(2) Rear light housing assembly .

3 - COMPOSITION OF THE REPLACEMENT PARTS

(1) Rear wing lower drip moulding assembly .

(3) Rear light location, central end .

(4) Rear light location, central section .

(5) Rear light location, outer end .

(6) Connector bracket, Left side only .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

(1) Rear wing lower drip moulding assembly .

(2) Rear light housing assembly .

5 - TOOLING

Case part number (-).1118 including the following tools :

• rear wing clamping tool [1]
• templates for marking the front chassis legs cut-outleft-hand side [2], right-hand side [3]
• front half panel [4] - [5] positioning templates

For the procedure, use the rear wing clamping tool .

6 - PREPARATION OF THE NEW PART

7 - CUTTING OUT

8 - RELEASING

9 - ADJUSTMENT

Rear wing clamping tool [1] .

10 - WELDING

11 - SEALING